ULTIMATEPRODESIGNS
Defaultcolor matte black .
The kit is precut only for the hood air intake, the rest (Bumper, Roof, rear trunk )stripes are not precut and need to be trimmed after installation,
Highgrade Vinyl as Factory Spec (Polymeric).
ManyColors, please Add a note on your order or messages on .
AvailableColors are:Matte Black - Gloss black - White matte - White gloss - Gold -Silver - Black - Grey - Yellow - Forest Green - Red - Blue - light Blue -Orange - lime green.
instalationinstractions
Step 1:Cleanthe vehicle surface thoroughly. Pay special attention to edges, and cracks thatmay be hiding dust or grime.
Step 2:Testfit by holding your vinyl in place with masking tape. Mark position with tape,or tape in place along top edge, allowing you to peel the backing paper. Makesure the decal is not backwards. Right side decals will only fit well on theright side of the car and vice-versa for the left side
Step 3:Wetvehicle surface with water solution (See general instructions above). Try toavoid getting the backing paper wet. It would cause it to break down and makeit harder to remove.
Step 4:Peelbacking paper and generously spray adhesive side of vinyl with water solution.
Step 5:Makesure positioning is correct. (Water allows you to temporarily slide the vinylaround the surface). Once you’re happy with the position, move to the nextstep.
Step 6:Ifworking with solid stripes, or unmasked vinyl, spray top of vinyl before yousqueegee to avoid scratches. If in doubt, spray more. It’s good to work withlots of solution, even on your hands.
Step 7:Firmlysqueegee vinyl in place, working from center out. If the vinyl moves at allwhile trying to squeegee, spray more solution and carefully reposition. Becareful not to stretch the vinyl too much as it might deform.
Step 8:Spraymasking / transfer tape to loosen and let sit for 5 minutes. This allows it toloosen enough and also give the vinyl time to stick better to the car’ssurface.
Step 9:Carefullypeel back masking / transfer tape, keeping it flat with the surface so youdon’t peel up the fresh vinyl. If some of the vinyl peels off you can addsolution and slip back into place and squeegee again.
Step 10:Trimextra overlap along edges with razor blade if needed. In more cases you won’tneed to trim, though some kits require it. Just be careful not to scratch thepaint when trimming. Most bubbles will squeegee out. However, some remainingbubbles can be carefully popped with a needle or corner of your razor bladebefore pressing down on it again.
Step 11:Parkin the sun to help the stripes dry quicker. The hot sun will also help get ridof some bubbles. Allow a few days with the car in a sun before attempting towash the vehicle. During this time, be gentle when you wipe down the car or thegraphics to avoid damaging them. After a few days you can begin to handle the caras you normally would.
PAYMENT POLICY
Accept PayPal.
We alwaysship the items when the payment is clear.
SHIPPING POLICY
Freeshipping worldwide.
Trackingnumber always provided within 24 hours.
Free internationalshipping takes 7-24 working days.
Trackingnumber can be track at the following link : track-trace.com/post
RETURNS POLICY
ReturnsAccepted (within 30 days after delivery).
Item Mustbe Return in its original condition for full refund (Not used).
Damagedproducts are refunded by providing evidence (photos).
If itemarrive damaged we are happy to send a free replacement (Please send a messagebefore open case, we are happy to resolving issues with customers.
CONTACT& SUPPORT
Responsewithin 24 hours.
We are happy to helpsolving any issue.
