ORIGINAL Sealed Ball Bearing Clutch Pedal Shaft Conversion / Support Repair For Sale - New and Used

Ball Bearing Clutch Pedal Shaft Kit
Specifications For MustangSteve Ball Bearing Clutch Pedal Shaft Kit

• Fits 64-1/2 to 73 Mustang, Falcon, Ranchero, Comet, Fairlane, All F-100 and F-150.
• Fits most other Fords using similar clutch pedal with 5/8\" shaft and a pedal support having parallel sides. These kits will also fit Camaro, Malibu, and other GM Products.
• Fix worn pedal supports, not fixed by other bearing kits.

The Problem

• Ford clutch pedals are attached to a pedal shaft and the shaft turns in the plastic bushings every time you press the pedal.
• Years of use and stiff clutches cause excessive wear and destroy/distort pot metal bushings retainers.
• Over time, bushings wear into the steel pedal hanger housing.
• Worn out plastic bushings cause greater pedal effort.
• Worn out bushings or retainers cause uneven pedal travel and an “out of position” clutch pedal.
• Worn out bushings cause the brake pedal to not have correct geometry and make braking harder.
• Replacement pedal support assemblies equipped with the same, inefficient plastic bushings cost $70 or more.

The Cure

• It can be used to repair worn-out, pedal support assemblies-- even your hopeless, “worst-case-scenario” projects.
• The bearings in this kit will fit perfectly on your original pedal shaft.
• All play from the clutch pedal will be removed, and make for a much smoother and stronger clutch pedal.
• Installation decreases pedal effort.
• This kit allows the use of stronger pressure plates or performance clutches without clutch pedal shaft wear.
• Price point for repair with MustangSteve Ball Bearing Clutch Pedal Shaft Kit will cost you less than purchasing a new pedal support assembly.

Additional Information about MustangSteve Ball Bearing Clutch Pedal Shaft Kit

• This kit includes industrial, quality sealed ball bearings, supported by precision-fit, sturdy, steel retainers that will be welded to the sides of your pedal support assembly and replace your worn-out pot metal bushings and plastic inserts.
• Compatible with your original clutch pedal shaft.
• Easy 1-hour modification or less-- once removed from your car
• Modification can be done with a stick, TIG or MIG welder.
• Instructions for simple step-by-step installation are included with purchase.

---