BRAND NEW PAIR OF ALUMINUM RAMPS.
94\" Long X 15\" Wide 2-3/4\" tall LOW PROFILE
1\" Hook Ends.6,000 LBS Per Axle Rating( 3,000 LBS Per Ramp )
pickup Trucks, Cars, And some small Tractors,
And other rubber wheeled vehicles that doesn\'t weigh more then 6,000LB per axle
FREE SHIPPING TO THE LOWER 48 STATES
READ ENTIRE LISTING BEFORE offerDING / BUYING Load Height 15\" up-to 36\"Ramps weigh 42 Pounds Each.
Very strong ramps, Will outlast lighter ramps rated for the same capacity.
You are buying ONE pair of Aluminum Ramps.
The Trailer pictured is not included.
Made from 6061-T6 ALUMINUM. Tensile Strength of 42,000 PSI
Cheaper ramps use 6063-T6 which is only 28,000 PSI.Serrated Cross bars for the best traction.94\" Long X 15\" Wide X 2.75\" Thick, & weighs 42 Pounds each.Half Knife Ends. NOTE:
A True knife end on a aluminum ramp will BEND if the top of the ramp is hooked higher then what it\'s made for.
Hook Ends, easy hook and load.Our Knife foot is wrapped, not a another piece welded on the bottomwhich will make the ramp tear at the start of the knife where they weld across.You are buying One PAIR = ( 2 Ramps )1 PAIR OF ALUMINUM RAMPS.
94\" LONG.
15\" WIDE.
2.75\" THICK
Loading height 15\" up-to 36\"
Weighs 42 Pounds Each.
1\" 90 Degree hook ends.
Serrated Cross bars for better traction.
Made in the USA
(note: the ramps can have a slight flex/curve when made, with all the welding across the top)
( All Measurements are Plus or Minus 1/4\" )
Pictures are a closerepresentation of the ramps there could be some slight Variations.
1 Year Limited Warranty, against material, workmanship, and defects, not for overloading.
Not Recommended for steel tracked vehicles, tractors, skid loaders, forklifts, or pallet Jacks. RETURNS: We accept returns within 30 days for a FULL REFUND MINUS 20% for shipping and handling,
Ramps must still be in original packaging, and UN-used.FREE SHIPPING TO THE LOWER 48 STATES,
If your outside the lower 48 STATES email address and Zip code for extra cost of shipping. Thank You.