Free shipping in USASame day shipping visit our store >
find parts for :
- ATV / UTV / SXS
- Watercraft
- Other
MenuStore Home
- find parts for
- ATV / UTV / SXS
- Watercraft
- Other
Series Machined Aluminum Regulator 50amp for Polaris Outlander 400 / max 400 2007 2008 | OEM Repl. # 703500717 KEY FEATURES
RUNS 33% COOLER THAN OEM PART: RMSTATOR exclusive aluminum alloy formula optimize the heat transfer from electronic parts to outside casing better than any other cast casing, including OEM parts.
STURDY CONSTRUCTION: Our voltage regulator casing is machined from a high quality billet aluminum block using precise automated CNC machine making the part stronger than imprecise casting process.
STRONGER CORROSION PROTECTION: Our colored anodizing process add a protective layer on the part to keep it from corroding.
PRO-FIT SYSTEM: Includes everything required to perform a RMSTATOR-style professional installation like opposite connectors and dielectric connector grease to get rid of OEM corroded harness connectors.
PURCHASE WITH CONFIDENCE: 2-Year warranty. All products are rigorously tested.
DESCRIPTION
2006 2007 Can-Am Outlander 400 fitment requires a special installation. Refer to the ?Installation? tab at the bottom of this page to see all the details
Battery condition is extremely important. No voltage regulator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.
BENEFITS OF SERIES VOLTAGE REGULATORS
SERIES regulators run much cooler than the Shunt and MOSFET voltage regulator rectifier and way much cooler than OEM parts.
Moreover, the regulator has our new machined billet aluminum casing which dissipate heat 33% better than standard molded casing.
Power only flows through the electrical components when the battery is charging.
Allows the stator to have lower current flowing when not used, extending its lifetime.
ABOUT THE SERIES VOLTAGE REGULATION TECHNOLOGY
RMSTATOR?s new SERIES voltage regulator brings better reliability and charging system performance. A SERIES regulator is a significant upgrade over typical shunt type voltage regulators.
A shunt regulator controls battery voltage by grounding the stator coils to dissipate current as heat, rather than sending it on to the battery. SERIES regulators control battery voltage by intermittently disconnecting stator coils from the regulator electronics, limiting current flow through the unit and on to the battery completely.
This results in lower regulator and stator temperatures, more accurate voltage regulation, and increased reliability of your charging system components.
INSTALL LIKE A PRO
We include the opposite connector (main harness side) as we know these are often melted / corroded / defective. Defective connectors are a major cause for repetitive electrical issues.
Vehicle models fitment
Can-Am Outlander 400 -- 2006-2007
Can-Am Outlander Max 400 -- 2006-2007
OEM part 103 mm
Length: 103 mm
Height: 28 mm
Fixation holes center to center: 80 mm
Other specifications:
Number of plugs: 2
Number of pins: 5
Minimum Charging Voltage: 14.5 V +/- 0.5 V
Maximum Charging Current: 50 A / 500 W
Open Circuit Voltage: < 15 V
Operation Temperature: -20?C to 85?C
instructions
Before installing your new CNC Mosfet Voltage Regulator Rectifier :
- Check the AC output of the stator
- Replace any burned or corroded connectors on stator and regulator rectifier
- Check and repair any melted wiring
- Use hi-temp dielectric grease on all connectors
2006 2007 Can-Am Outlander 400 Installation Particularities
If you are using this regulator for 2006 2007 Can-Am Outlander 400 fitments, it will function perfectly fine. You will need convert your vehicle wiring to our included mating connectors.
From your original stator connector, the outer 2 Yellow wires will be spliced into 1, the center 2 Yellow wires will be spliced into 1, and the opposite outer 2 Yellow wires will be spliced into 1. These go into our Grey connector in any location, there is no order.
The Red Battery + goes to the inner terminal of the Black connector. The Brown Battery - (ground) wire goes to the outer terminal of the Black connector. The center terminal of the black connector is not used.
You will need relocate or build a mounting bracket for this regulator, it will not mount like the original regulator for this application.
SHIPPING
We deliver 99.4% of our orders within the specified time period. If your item is not available in our main Colorado facility, we still guarantee that your order will be delivered within the specified time period.
If your item is not delivered within this time period, we will offer you a 5.00$ discount on your order. This guarantee applies to shipments delivered in the 48 continental USA states, excluding PO boxes.
Videos customer service
AsK seller a question duties & taxes
International Buyers:
Import duties, taxes, and charges are not included in the item price
or shipping cost. These charges are the buyer\'s responsibility.
RaceTech Electric was founded in 2011 by three motorcycle industry veterans in San Diego, CA. The group has over 20 years combined in the Motorcycle industry.
Customer service
About us
- About seller page
- Add seller to favorite
