*** YOU CAN BUY THIS PRODUCT MUCH LESS EXPENSIVE DIRECTLY ON :
www.GruvenParts.com
It is the 1st item listed in the GM Trucks Section.
*** NOTE TO BUYERS :
You Cannot Just Install the Metal Gear Without Also Changing The OEM Motor. The OEM Motor is Externally Grounded, So You Will Short Out and DESTROY the Body Control Module If You Merely Install a Metal Gear without Also Swapping the Motor to 1 that is INTERNALLY GROUNDED !!! DONT MAKE THIS MISTAKE !!!
GruvenParts.com Sells Both the METAL INTEGRAL Replacement Gear WITH the NEW Hi Torque Motor That Is Internally Grounded and MEANT TO WORK With Metal Gears - Dont Just Replace the Gear, You Must Replace Both Gear AND Motor When Going to Metal !!! *** Somehow there are other sellers that havent figured this out yet. Don\'t replace it with cheap plastic and DEFINITELY DONT replace only the gear with a metal gear, or you will short out a $1,000 body control module !!!
*** YOU CAN BUY THIS PRODUCT MUCH LESS EXPENSIVE DIRECTLY ON :
www.GruvenParts.com
It is the 1st item listed in the GM Trucks Section.
On that page you can also access the excellent DIY instructional video, write up, and you have several other options (buy complete drive units already rebuilt, etc...). There are also LIVE COUPON CODES from time time. There are also many other excellent GM products in that same section of our site, so check them all out. We have sold thousands of these products to GM truck owners. Research the forums, we are the best vendor for these replacement parts, we have been around since 1999, we build our parts in Atlanta, GA, and we provide a LIFETIME WARRANTY on these parts. The guys from Turkey will be gone tomorrow after they short out your BCM, WE WONT.
--- THE PRICE LISTED HERE IS FOR 1 GEAR + 1 MOTOR. BUY IT DIRECT ON www.GruvenParts.com Website - 1st item in the GM Trucks Section, as its MUCH LESS EXPENSIVE THERE ! AND THERES MORE OPTIONS...
HIGH STRENGTH GEAR BRASS AND NEW INTERNALLY GROUNDED HIGH TORQUE MOTORS ... BECAUSE PLASTIC GEARS BREAK !!!!
** Product Description **
GruvenParts.com is pleased to announce replacement strengthened BRASS spur gears and high torque INTERNALLY GROUNDED motors (OEM MOTORS WONT WORK WITH METAL GEARS) for the power folding mirrors on 2007-2014 GM trucks including Acadia, Traverse, Enclave, Escalade, Silverado, Avalanche, Tahoe, Suburban, Sierra, Yukon, and Denali. Also fits 2007-Present GMC pick-up trucks. As many have discovered, the folding mirror assembly on these trucks suffers from a thin, weak, plastic spur gear mounted to the main drive shaft. The plastic spur gear cracks at the slightest impact or just wears out over time causing an inoperable folding mirror. The GM motors also get weak and die quickly. Unfortunately, GM will only sell you a complete folding mirror assembly, which will cost you from $700-$1,200 ea after labor and paint, depending on the year/make/model. And that $ would be wasted on another mirror assembly with another weak, plastic spur gear and weak electric motor that will also soon fail. Don\'t waste time or hard earned money on more GM parts that will also soon fail!
GruvenParts.com has addressed this issue by designing a strengthened spur gear made from solid gear BRASS with a thicker cross section to eliminate the stress concentrations which cause fatigue cracking in the GM plastic gear. We have also designed a replacement high torque electric motor to accompany this new metal gear. Our new electric motor is required when switching out to the metal gear, as the ground circuit in the OEM motor does not allow for a metal gear to be installed. You can buy the gear/motor combo for one of both sides, and with the spur gear pre-attached to a new main shaft, or loose. Loose gear orders require installation of the spur gear onto the main shaft using 24 hour epoxy - please refer to the DIY article link above. We have thoroughly tested our redesigned spur gear and high torque motor using a new, OEM mirror assembly and computerized test equipment. Our test samples barely showed any wear whatsoever, and the testing did include random wacks against the mirror, jamming the mirror operation as it was folding, and manually stressing the mechanism all in an attempt the break the gear. Each sample was tested more than 5,000 open/close cycles and was still going strong at that point !
This product carries a LIFETIME WARRANTY! Provided you don\'t burn the vehicle, or otherwise smash the mirror into something, you can send back the motor drive unit to us and we\'ll replace the gear assembly and get it working again free of charge. You would only be responsible for shipping under this warranty.
** Application **
Gears and Motors Fit Both Passenger and Drivers Side Power Folding Mirrors.
All 2007-2014 GM SUV\'s With Power Folding Non-Tow Mirrors Including Acadia, Traverse, Enclave, Escalade, Tahoe, Suburban, Yukon, and Denali.
All 2007-Present GM Pick Up Trucks Including all Silverado and Sierra with Non-Towing Power Fold Mirrors
This includes (but not limited to) the following mirror assembly part numbers :
25-83-12-36 (25831236), 25-77-98-49 (25779849)
This list of part numbers will continually grow as we build the interchange list. This is in no way complete, as most GM trucks made from 2007-2014 with power folding mirrors will use this gear. If your power folding mirror looks like the mirror shown in the DIY, this gear will fit your vehicle.
... We also have many more products for GM, including the towing mirror gears, 2015-Present SUV non-towing mirror gears, door lock motors, door handle inserts ! Check out the GM section of our website!
Other Parts Available :
We also carry a limited number of used parts to service these mirrors in case you loose or break something. We have some of everything, so just email us by clicking Contact Us on www.gruvenparts.com website if you need something. We do now have some used mirror glass drive units for both sides - these are the little motorized units that actually adjust the angle of the mirror glass
