1.Fitting the FORD RANGER 4WD2.Package Includes:2x Front Wheel Hub Bearing -5150522x Front Sway Bar End Link -K72752x Front Outer Tie Rod End -ES34612x Front Inner Tie Rod End -EV3171x Front Upper Control Arm And Ball Joint - Driver Side -K8708T1x Front Upper Control Arm And Ball Joint - Passenger Side -K800682x Front Upper Ball Joint -K8738Notes For 2003-04 FORD RANGER 4WD 12Pcs Front Wheel Bearning Hub Sway Bar Tie Rod End
1.Fitting the Followingvehicle:
2003-2004 FORD RANGER 4WD
2.Package Includes:
2x Front Wheel Hub Bearing -515052
2x Front Sway Bar End Link -K7275
2x Front Outer Tie Rod End -ES3461
2x Front Inner Tie Rod End -EV317
1x Front Upper Control Arm And Ball Joint - Driver Side -K8708T
1x Front Upper Control Arm And Ball Joint - Passenger Side -K80068
2x Front Upper Ball Joint -K8738
Notes
(1).Please check the fitment chart above before payment makingsure all the suspension parts listed on this page are compatible with your automobile.
(2).Please refer to Moog official website before narrowing down your search so as to avoid unnecessary item not as described return requests.
(3).Please contact our customer services for targeted discount after all the items are received if you have reached any targeted discount thresholds, the terms of which is atthe bottom of thispage.
If you are interested with anyothersuspension parts, please click and saveour store.
Ball JointReplacement Guideline:
If there is a knocking or clunking noise in the area of the front axle when the car is traveling over road bumps, potholes or curbs, then there is usually a defect in a component of the wheel side of the front axle from which the (vibration) noise is emanating can already be determined during a test drive. The type of noise also already provides certain indications for maintenance regarding which components might be />1.Raise the vehicle and remove the front wheels.
2.To loosen the fastening screws and fixing nuts of the compression ball joint more easily, spray them with rust remover and allow to act for a few minutes.
Picture(C)
3.Loosen the fastening screws of the broken ball joint on the control arm and remove the nuts.
Picture(D)
4.Loosen and remove the fixing nut of the ball joint on the steering knuckle.
Tip:If the ball stud rotates, hold the ball stud in place with a hexagon socket.
Picture(E)
5.Remove the bad or worn ball joint from the control arm.
6.Loosen the compression ball joint on the steering knuckle using a suitable special tool.
Picture(F)
7.Clean the cone connection.
Tip:For better sealing and durability of the ball joint sleeve, a little silicone grease can be applied to the contact surface.
Picture(G)
8.Insert new compression ball joint in the control arm and steering knuckle and tighten with new fixing nuts.
9.Reinstall front wheels. Lower the vehicle and tighten the wheel studs to the tightening torque specified by the vehicle manufacturer.
10.Measure the chassis and adjust it using the various holes on the compression ball joint if necessary.
11.Finally, carry out a test drive.
"
Item SpecificsBrand :autoutdoorType :Control Arm & Ball Joint AssemblyUniversal Fitment :NoIncluded Hardware :Mounting HardwarePerformance Part :NoInterchange Part Number Part Number :tie rod end,rods ends,wheel hub bearing assembly,hubs bearingsOE/OEM Part Number :sway bar,Suspension arm Kit,replacing control arm car,rods endsFinish :CoatedManufacturer Warranty :10 YearPlacement on Vehicle :FrontManufacturer Part Number :ADD84135202RAdjustable :YesMaterial :Alloy SteelKit or Single Part :KitGreasable or Sealed :GreasableOE Spec or Performance/Custom :OE SpecSurface Finish :Polished, Rust ProtectedQuantity :12PcsItems Included :Mounting HardwareABS Sensor :Has ABS with tegral SensorBolt Circle Diameter :14.86666518cm
Payment
- WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
- Instant Paypal payment is the preferred method of payment.
- We will only ship to the confirmed Paypal shipping address given with the payment.
- We do not offer local pickups.
Shipping
1. Orders processed within 24 hours of payment verification.(if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.)
2. We only ship to confirmed PAYPAL addresses. Your PAYPAL address must match your Shipping address.
3. The images shown are not the actual item and are for your reference only.
4. Fast shipping:All our packages use USPSPackage Service
5. If you have not received your shipment within 15 days from payment , please contact us. We will track the shipment and get back to you as soon as possible with a reply. Our goal is customer satisfaction!
Returns
1. You have 7 days to contact us and 10 days to return it from the date it was received. If this item is in your possession more than 7 days, it is considered used and we will not issue you a refund or replacement. There are NO EXCEPTIONS!
2. All returned items must be in the original packaging and you must provide us with the shipping tracking number, specific reason for the return, and item custom lable.
3. We will refund your full winning offer amount, upon receipt of the item in its original condition and packaging with all components and accessories included, AFTER both Buyer and Seller cancel the transaction from . OR, you may choose to have a replacement.
4.Return shipping is to be paid by the Buyer.
Contact Us
- We are always been trying to provide best service and reliable products for every customer.
- If you are satisfed with the product you recieved,please leave us positive response.
- If you are not satisfied for any reason, please do not be quick to leave negative or neutral response.We will work hard to make sure every customer 100 percent satisfied, and reslove any problem for you.
Shop CategoryStore Home Brake Rotors & Pads◈Brake Pads suspension kit◈suspension kit-chenjiao◈suspension kit-fu◈suspension kit-gxy◈Suspension Kits Exterior◈Spoilers & Wings◈Body Kits Turbos & Parts Axle Housings & Parts Motor◈Transfer Case Motor◈Running Board Motor◈Window Regulator Other
Hot Item 1998-2004 For Ford Ranger 10Pcs Front Control Arms Ball Joints Tie Rods Kit USD 98.00 15Pcs For 99-04 Jeep Grand Cherokee New Suspension Control Arm Tie Rod Sway Bar USD 136.88 For 1989-1994 1995 Toyota Pickup RWD 12pcs Suspension Tie Rods Center Link Kit USD 118.50 Fits 2002-2005 Honda Civic 12Pcs New Front Lower Control Arms Sway Bars Tie Rods USD 125.88 For 2000-13 Chevy Impala 8PCS Front Lower Control Arm Sway Bar Tie Rod Ends Kit USD 86.99 New List Item Set of 2 For 2005-2014 Arctic Cat 400 Rear CV Axle Drive Shaft USD 108.92 For 2021–on BMW G22 4-Series G80 M4 Coupe Carbon Fiber Trunk Spoiler USD 109.92 Fit for 2001-2007 Ford Escape Front Left Window Regulator with Motor 741-604 USD 39.84 FITS Ford F250 Excursion 7.3 Powerstroke 1999-2003 GTP38 GTP38R Turbocharger USD 221.92 K03-0470 Turbocharger Fits Ford Expedition 3.5L 2015-16 Navigator 3.5LRight Side USD 175.92 For 2003-04 FORD RANGER 4WD 12Pcs Front Wheel Bearning Hub Sway Bar Tie Rod End
1.Fitting the Followingvehicle:
2003-2004 FORD RANGER 4WD
2.Package Includes:
2x Front Wheel Hub Bearing -515052
2x Front Sway Bar End Link -K7275
2x Front Outer Tie Rod End -ES3461
2x Front Inner Tie Rod End -EV317
1x Front Upper Control Arm And Ball Joint - Driver Side -K8708T
1x Front Upper Control Arm And Ball Joint - Passenger Side -K80068
2x Front Upper Ball Joint -K8738
Notes
(1).Please check the fitment chart above before payment makingsure all the suspension parts listed on this page are compatible with your automobile.
(2).Please refer to Moog official website before narrowing down your search so as to avoid unnecessary item not as described return requests.
(3).Please contact our customer services for targeted discount after all the items are received if you have reached any targeted discount thresholds, the terms of which is atthe bottom of thispage.
If you are interested with anyothersuspension parts, please click and saveour store.
Ball JointReplacement Guideline:
If there is a knocking or clunking noise in the area of the front axle when the car is traveling over road bumps, potholes or curbs, then there is usually a defect in a component of the wheel side of the front axle from which the (vibration) noise is emanating can already be determined during a test drive. The type of noise also already provides certain indications for maintenance regarding which components might be />1.Raise the vehicle and remove the front wheels.
2.To loosen the fastening screws and fixing nuts of the compression ball joint more easily, spray them with rust remover and allow to act for a few minutes.
Picture(C)
3.Loosen the fastening screws of the broken ball joint on the control arm and remove the nuts.
Picture(D)
4.Loosen and remove the fixing nut of the ball joint on the steering knuckle.
Tip:If the ball stud rotates, hold the ball stud in place with a hexagon socket.
Picture(E)
5.Remove the bad or worn ball joint from the control arm.
6.Loosen the compression ball joint on the steering knuckle using a suitable special tool.
Picture(F)
7.Clean the cone connection.
Tip:For better sealing and durability of the ball joint sleeve, a little silicone grease can be applied to the contact surface.
Picture(G)
8.Insert new compression ball joint in the control arm and steering knuckle and tighten with new fixing nuts.
9.Reinstall front wheels. Lower the vehicle and tighten the wheel studs to the tightening torque specified by the vehicle manufacturer.
10.Measure the chassis and adjust it using the various holes on the compression ball joint if necessary.
11.Finally, carry out a test drive.
"
Item SpecificsBrand :autoutdoorType :Control Arm & Ball Joint AssemblyUniversal Fitment :NoIncluded Hardware :Mounting HardwarePerformance Part :NoInterchange Part Number Part Number :tie rod end,rods ends,wheel hub bearing assembly,hubs bearingsOE/OEM Part Number :sway bar,Suspension arm Kit,replacing control arm car,rods endsFinish :CoatedManufacturer Warranty :10 YearPlacement on Vehicle :FrontManufacturer Part Number :ADD84135202RAdjustable :YesMaterial :Alloy SteelKit or Single Part :KitGreasable or Sealed :GreasableOE Spec or Performance/Custom :OE SpecSurface Finish :Polished, Rust ProtectedQuantity :12PcsItems Included :Mounting HardwareABS Sensor :Has ABS with tegral SensorBolt Circle Diameter :14.86666518cm
PaymentShippingReturnsContact Us
- WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
- Instant Paypal payment is the preferred method of payment.
- We will only ship to the confirmed Paypal shipping address given with the payment.
- We do not offer local pickups.
1. Orders processed within 24 hours of payment verification.(if you want cancel orders or change address pls contact us within 6 hours after payment,or we are not responsible for shipping a replacement.)
2. We only ship to confirmed PAYPAL addresses. Your PAYPAL address must match your Shipping address.
3. The images shown are not the actual item and are for your reference only.
4. Fast shipping:All our packages use USPSPackage Service
5. If you have not received your shipment within 15 days from payment , please contact us. We will track the shipment and get back to you as soon as possible with a reply. Our goal is customer satisfaction!
1. You have 7 days to contact us and 10 days to return it from the date it was received. If this item is in your possession more than 7 days, it is considered used and we will not issue you a refund or replacement. There are NO EXCEPTIONS!
2. All returned items must be in the original packaging and you must provide us with the shipping tracking number, specific reason for the return, and item custom lable.
3. We will refund your full winning offer amount, upon receipt of the item in its original condition and packaging with all components and accessories included, AFTER both Buyer and Seller cancel the transaction from . OR, you may choose to have a replacement.
4.Return shipping is to be paid by the Buyer.
- We are always been trying to provide best service and reliable products for every customer.
- If you are satisfed with the product you recieved,please leave us positive response.
- If you are not satisfied for any reason, please do not be quick to leave negative or neutral response.We will work hard to make sure every customer 100 percent satisfied, and reslove any problem for you.
Copyright of autoutdoor. All rights reserved.
