YOU ARE NOT BUYING THE UNIT SHOWING, YOU NEED TO SEND YOURS INTO BE REPAIRED....
**********Please ignore the estimated shipping time that I have listed on this sale….! Due to ’s new handling time policy it does not allow for the shipping time that it takes for you to ship it to me and for me to repair your unit and then they would penalizes me for appearing to have slow shipping/handling time(WHICH I DO NOT). So I have to enter a very ridiculous long handling time so I do not fall out of their parameters, so I can still beTrusted and Greatseller also. My actual handling time for repairs are once I receive your item for repair it is a ONE DAY or the SAME DAY turn around and then I ship it back to you right away..! If you have any questions at all feel free to contact me thru messaging.************
Thanks David
Is your Ford 6.0 Diesel Truck having any of the following problems? If so then I’m here to get you back up and running again…
This module fails causing problemswith your Truck, P0611 code , FICM part # 4C3Z-12B599 ABRM,,,,,, like not to start or slow cold start and very poor fuel economy and power loss…if this is so, then your FICM (Fuel Injection Control Module) is more than likely bad and needs to be repaired…
I have identified the failure and can repair and upgrade your FICM with a permanent solution to your problem…
And this repair comes with aLIFETIME warranty…..
ALSO REMEMBER THAT THIS IS A REPAIR SERVICE TO YOUR UNIT… YOU MUST SEND YOU BAD FICM INTO ME TO BE REPAIRED AND THEN I SEND YOURS BACK TO YOU…..
PLEASE DO NOT SEND A FICM THAT HAS BEEN UNDER WATER OR THAT HAD SMOKE COMING FROM IT,,, WE WILL NOT REPAIR THEM,.
-*If you are not sure if this service is for you just CALL .
· THIS REPAIR SERVICE TO YOUR FICM WILL COVER THE FOLLOWING VECHICLES LISTED BELOW, Equipped with a International Module ,,,,
2003 to 2005 FORD EXCURSION
How to test FICM to see if it is bad.........
On top of the FICM you will see small rectangular plate with 2 T20 torx screws. Remove them and pull the plate off,,, YOU MUST ONLY TOUCH THE SCREW CLOSET TO THE DRIVER SIDE, AND BE VERY CAREFUL NOT TO TOUCH ANYTHING ELSE WITH YOUR METER LEAD…, check that screw (DC Voltage) to battery ground, you should measure 45 volts or above , If the voltage measured is less than 45 volts then your FICM needs repair…
PLEASE KEEP IN MIND THAT SOME UNITS MAY NOT BE REPAIRBLE AND IF THAT IS THE CASE, I WILL REFUND YOUR MONEY AND SEND YOUR UNIT BACK TO YOU,,,,,,,,
This repair to your FICM does not require and programming to you unit…
- What you have to do after winning this FICM REPAIR SERVICE..
-
-
- Remove your defective FICM by disconnecting your battery.
-
- TAKE YOUR DEFECTIVE FICM OFF OF THE VALVE COVER (driver’s side, must look like the one in the picture) AND SEND IT TO ME WITH PAYMENT OR COPY OF THE PAYPAL TRANSACTION..
The FICM is held down by 4 bolts, so remove them and then disconnect the 3connectors that are plugged into the FICM……
- Pack your FICM in bubble wrap and put in a good box,,,,,, NO peanut packing stuff…..
The day I get your FICM it will be repaired and tested and shipped back out the next business day by 2nd day ups,
You pay for shipping your FICM to me …..
SEND YOUR DEFECTIVE FICM TO:
Due to s policy I can not give out areaddress or phone number until after you have paid.
Areaddress will be emailed to you after you buy and have paid for thisservice.
What you need to know….
-I repair your FICM WITH my HIGH REPAIR STANDARDS, that is why I can put aLIFETIME WARRANTY on it AND nobody else on can do this.
-They are having a lot of problem with this FICM for the VECHICLES above, how do I know. Because over the past7 years I have repaired over 2,300 of these FICM for people like you.
A little about me…..
I have 25 years in the Automotive Electronic field. I have repaired over 2,300 of these FICMforpeople like you. I stand behind my work so you can purchase this FICM REPAIR SERVICE WITH Confidence. Happy offerding I hope you win it.
Contact and Shipping information….
-Shipping:Within the 50 U.S. states (UPS ground, or USPS)
