Humanized Design
Ensure a tight seal and smooth steering operation. The hydraulic lines are fully fluid tested at high pressure. And the steel clamps and rubber bellow boots improve steering Include
1PCPower Steering Rack and Correctly select the model and size of the steering gear: The model and size of the steering gear must be consistent with the original parts of the vehicle, otherwise it will affect the steering sensitivity and stability;
2. Clean the surrounding area first: Before replacing the steering gear, it is necessary to thoroughly clean the surrounding area to prevent small debris residues from damaging new steering gear components;
3. Correct disassembly and assembly of the steering gear: When disassembling an old steering gear, be particularly careful to avoid damaging the original vehicle components, and lubricate the bearings and gears during installation;
4. Use of high-quality steering oil: For hydraulic power assisted steering machines, high-quality steering oil is required;
5. Correctly adjust the wheel angle: After replacing the steering gear, it is necessary to adjust the wheel angle to ensure vehicle stability and safety;
6. Attention to maintenance: Regularly inspect and maintain steering gear components to ensure good operation of the steering leakage: The oil seal in the steering gear can break due to aging and wear, resulting in loss or leakage of hydraulic oil. Oil leakage can cause difficulty or malfunction in steering operation.
Abnormal noise: A snap, noise, or hiss may be caused by worn steering gear, pin shaft, or rack.
Excessive steering force: Blockage or wear of the steering gear oil pipes or passages can cause excessive hydraulic oil pressure, excessive steering force, or even steering failure.
Steering failure: Steering failure can be caused by reasons such as damage to the steering gear, blockage in the oil circuit, and failure of the oil pump, which will affect driving safety.
Shake or shake: Worn or loose parts in the steering gear can easily cause the vehicle to shake or shake during steering.
Dead center: When turning, if the steering wheel needs to be rotated for a long time until the vehicle turns significantly, this may be a dead center problem with the steering gear.
US warehouseshippingpaymentContact US
SHIPPING:USA Shipping Notice - All items will be dispatched within 24hrs(Mon-Fri)
We will reply every message and solve the problem within 24 hours(except holiday). If you have any problems or concerns whatever with your order or products, please mail us and give us a chance to assist you before leaving any response. We maintain high standards of excellence Postive response and strive for 100% customer satisfaction! response is very important to us. We hope that you contact us immediately BEFORE you give us neutral or negative response, so that we can satisfactorily address your concern.
