Project Exhaust 2.5 Inch Rear Engine X-Pipe | Stainless
This 2.5 inchrear engine X-pipe is a universal fit for just about any vehicle with that configuration. We specifically designed our X-pipe to have a merge section that wasn't overlyaggressive to give you the max power possible, without sacrificing on sound. If wemade any larger of a crossoverthe exhaust pulses would have too much turbulence. If you look closely and follow the exhaust pathyou will notice that both exhaust sides won't travel over into the other stream of exhaust so easily. This will allow the gases to collide with eachother in the center crossoverwith the right amount of force before they travel back on course. We stand behind our design and want to thank you for being patient as we continue to roll out new products. These are all made with 304 stainless steel and 100% TIG welded with heavily overlapped welds for maximum strength.
FEATURES
2.5" (Outer Diameter) piping in 304 stainless steel
1.5mm thick tubing
308L stainless steel filler rod used for all TIG welds
Precision cut bends + Deburring before welding
Extra overlapping welds to ensure strength
Custom brackets added to prevent stress cracks
6.75" wide x 7.75" high
2.625" spacing between pipes
Brushed/Polished finish
Manufacturer's Part Number (MPN):PE-25REARX-2625
We stand by our workmanship and want you to feelat peace.This is why allx-pipes comewith aLIFETIME WARRANTY against defects, whichinclude cracking. In order to be eligible,the x-pipemust not be modified in any way and NO heat wrapis allowed.We will replace your X-Pipe and sendyou a new one Free of Charge.All we ask is thata picture be sent to us for verification of the damage.(Only the original purchaser of the x-pipeis coveredunder the initial warranty with a providedOrder Number).
