Another Awesome Product By
Free Bird Innovations, Inc.
Kit Includes 100PCS and the Installation instructions
100pcs is enough to do your wings. You\'ll need additional kits if you want to add to your stabilizers
Made from Polycarbonate material with UV protective additive
It has been know for some time now that vortex generators reduce stall speeds and improve the aircraft’s handling performance. Vortex generators allow the wing to develop more lift and lower airspeeds. This reduces takeoff speed and improves the rate of climb. Vortex Generators also retain positive aileron control and enhance your rudder authority in higher angles of attack. You will immediately notice an improvement in your aircraft.
HOW TO THEY WORK?
As air normally flows over the wing of an aircraft in flight, the air \"sticks\" to the surface of the wing. This adherence to the wing\'s surface produces lift. If the airflow loses its adherence and separates from the wing, aircraft performance can suffer in the form of increased drag, loss of lift and higher fuel consumption.
Researchers at NASA Langley Research Center developed Micro VGs to control this flow detachment by producing miniature, controlled tornadoes, called \"vortices\". The Micro VGs sweep away uncontrolled airflow separation over the airplane\'s wings and flaps with the benefit of reduced drag and increased lift (i.e., less engine power needed to produce the same lift).
Micro VG technology contributed to performance and safety improvements as well as cost and noise reduction for the aerospace industry. Its relatively simple design and ease of installation make Micro-Vortex Generators one of the most cost-effective means of aircraft safety and performance enhancement.
The instructions will show you exactly where to install your AirWave VG’s. It is recommended to temporarily apply them with double stick tape before bonding them permanent with either Loctite® “Prism” 401 cyanoacrylate adhesive or Pacer® Technologies (Super Glue) “Plasti-Fuse” #15104 (with primer/activator included) or Permatex® “Auto Trim Adhesive” #80885 (with primer/activator included)
Note: These Airwave Vortex Generators are not rated for certified aircraft. They are designed and intended for experimental aircraft and ultralights. Experimentals that already have type certificates may need to contact the local FSDO to see if installation of VG’s constitutes a major alteration and may require a testing period.
Posted with the Android app