ECCPP- Headlights AssemblyFit For:2006-2011 Honda Civic 2 Door CoupePackage Includes:Pair Headlight Assembly Left + RightFeatures:Plug and Play Operation, Direct Bolt-On OE Fitment or Replacement for the Stock UnitComes with a Complete Set of Headlights (Driver and Passenger Side)Brings a Different Appearance to Vehicle thats Great for Show Use or to Replace Old and Worn HeadlightsRequires no Modification or Drilling Pair Headlights Assembly For 2006-2011 Honda Civic 2Dr Black Kit Headlamps Set
ECCPP- Headlights Assembly
Fit For:
2006-2011 Honda Civic 2 Door Coupe
Package Includes:
Pair Headlight Assembly Left + Right
Features:
Plug and Play Operation, Direct Bolt-On OE Fitment or Replacement for the Stock Unit
Comes with a Complete Set of Headlights (Driver and Passenger Side)
Brings a Different Appearance to Vehicle thats Great for Show Use or to Replace Old and Worn Headlights
Requires no Modification or Drilling
Brand New and High-quality
Waterproof:The whole sealing construction can prevent moisture from entering the inside of housing.
Dust proof:The full sealed design will prevent the ingress of rain, dust and other foreign matter.
Heat Dissipation:With efficient heat dissipation, the construction of headlight will be protected and its useful life will be extended.
Note:
1.High quality lights.Safety and Durable.
2.DOT/SAT approved for street legal. Safety & Fashion.
3.High grade ABS plastic. For toughness, impact resistance, and heat resistance.
4.Condition: 100% Brand New and High Quality
5.Material: ABS Plastic Housing / Polycarbonate Lens
6.100% Brand New!
7.Professional Installation is Highly Recommended.
8.Installation Instruction is NOT Included.
Installation:
Install:
1.Undo the screws, clips, or retainer springs that hold the headlight in place.
2.Disconnect the wiring from the assembly.
3.Detach the headlight from the vehicle to replace it with a new one.
4.Fit in the new headlight assembly.
5.Fix the new headlight into place and make sure that the screws, clips, or retainer springs used are sealed.
6.Reconnect the wiring that was unplugged from the assembly.
7.Put back the grille and other components that you removed. Seal them back into place.
8.Test the new assembly.
Adjust：
Before you begin to adjust the light, make sure check the alignment of your lights first. Park the vehicle about 10 to 25 feet from the wall with the lights aimed at the wall. The centerlines of the headlights should not be any higher than 3.5 feet above the ground.
1. 【Find the adjustment screws】Firstly, locate the adjustment screws on your vehicle.
2. 【Adjust the headlights individually】The headlights should be adjusted one at a time. Put a rag or towel over a chair in front of the light you want to block. Covering the light assembly directly can damage the plastic lens.
3. 【Adjust the vertical field】The screw on the top of the light housing should be turned clockwise to raise the lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light beam shines directly on or just below the center of the tape line on the wall.
4. 【Adjust the horizontal field】The screw on the side of the light housing should be turned to get the right/left adjustment correct. Adjust the lens so that the most intense part of the beam is to the right of the vertical line.
5. 【Test your results】
Item SpecificsManufacturer Part Number E16010201CPBrand ECCPPPlacement on Vehicle FrontInterchange Part Number 33151-SVA-A11Superseded Part Number For 2006-2011 Honda Civic 2 Door CoupeLighting Technology HalogenHeadlight Style ReflectorHousing Color BlackLens Color ClearBulb Shape Code HB3 (9005)Fitment Type Direct ReplacementAssembly Type SealedBulbs Included NoManufacturer Warranty 10 YearsMounting Hardware Included NoShipping Country USCondition NewWater Proof YesComponents Included Lens and HousingLens Material PlasticFeatures SAE-CertifiedEasy&Hassle Free Returns YesFinish SmoothFitment Type Direct ReplacementComponents Included Lens and HousingNon-Domestic Product YesBallast Included No Item SpecificsManufacturer Part Number E16010201CPBrand ECCPPPlacement on Vehicle FrontInterchange Part Number 33151-SVA-A11Superseded Part Number For 2006-2011 Honda Civic 2 Door CoupeLighting Technology HalogenHeadlight Style ReflectorHousing Color BlackLens Color ClearBulb Shape Code HB3 (9005)Fitment Type Direct ReplacementAssembly Type SealedBulbs Included NoManufacturer Warranty 10 YearsMounting Hardware Included NoShipping Country USCondition NewWater Proof YesComponents Included Lens and HousingLens Material PlasticFeatures SAE-CertifiedEasy&Hassle Free Returns YesFinish SmoothFitment Type Direct ReplacementComponents Included Lens and HousingNon-Domestic Product YesBallast Included No
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
- PayPalpreferred.
PictureHot Item Front Wheel Hub Bearing For Chevy Monte Carlo Impala Cadillac Eldorado DTS FWD USD 40.38 ECCPP 2 Pcs Wheel Hub Bearing Front For Buick LaCrosse Century Regal Lesabre FWD USD 60.95 Universal 12V Low Pressure 5-9 PSI Electric Fuel Pump Installation Kit E8012S USD 14.15 Pair Manual Adjust Tow Mirrors For 1988-1998 Chevy GMC C K 1500/2500/3500 USD 62.99 Pair For 2007-2014 Chevy Silverado Sierra Towing Power Heated LED Signal Mirrors USD 124.69 Shop CategoryStore Home Air Dryer Car Tools◈Car Tools◈Electric Winch Tow◈Jack Stand◈Jumper Cable◈Removal Tool◈Tire Pressure Gauge Clutch System◈Clutch Slave Cylinder Cooling System◈AC Compressor◈Air Blend Door Actuator◈Blower Motor Resistor◈Condenser◈Coolant Tank◈Cooling Fan◈Evaporator◈Heater Control Valve◈Heater Hose◈Radiator Support◈Thermostat Housing◈Water Pump◈Water Pump Impeller Copper Tube◈ATV Brake Caliper◈ATV Brake Master Cylinder◈Brake caliper◈Brake drum shoe◈Brake lines kit◈Brake rotor pad◈Brake Shoe◈Clutch Lever◈Power Brake Booster Crankshaft And Camshaft◈Camshaft & Crankshaft◈Harmonic Banlancer◈Timing Chain Kit Drive Belt And Device◈Primary Drive Clutch◈Serpentine Belt Tensioner◈Wear Ring Drive Shaft And Half Shaft◈4 Pcs Wheel Hub Bearing◈C Notch & Flip Kit◈CV Axle◈CV Axle Boot◈Driveshaft◈Rear Wheel Axle◈Wheel Hub Bearing◈Wheel Hub Bearing Knuckle◈Wheel Hub Centric Rings◈Wheel Spacers Engine Bracket Glue◈Engine Mount Engine Gasket & Cylinder Head◈Carbon Seal◈Cylinder Head◈Cylinder Piston Gasket Kit◈Head Gasket Set Fuel System◈Car Carburetor◈Fuel Cell Gas Tank◈Fuel Injectors◈Fuel Pump Assembly◈Fuel Tank Pipe & Cap◈Fuel Tank Valve & Regulator◈Mass Air Flow Sensor◈Motorcycle Carburetor & Parts◈Oil Fuel Hose◈Purge Valve◈Vacuum Pump Gas Distribution System◈Diesel Emissions Fluid Pump◈Hydraulic Lifter & Rocker Arms◈Idle Air Control Valve◈Intake Carburetor Boot◈Secondary Air Pump◈Throttle Body◈Turbocharger◈Valve Cover Golf Series Home gardening◈Courtyard And Outdoor Supplies Ignition System◈ATV Ignition Coil◈Fuse Box◈Glow Plugs◈Ignition Coil & Spark Plug◈Ignition Coils◈Ignition Distributor◈Spark Plug Wire Set◈Wiring Harness Inner Parts◈Air Cleaner Box Assembly◈Car Floor Mats◈Car Seat Cover◈Cargo Cover◈Center Console◈Dash Cover & Cushion◈Fastener◈Remote Key◈Shift Knob Lever Head◈Steering Wheel & Adapter◈Sun Visor Lawn Mower Parts Light products◈Exterior Lights◈Fog Light◈Headlight Assembly◈Instrument Panel Lights◈Interior Lights◈Led Headlights◈Motorcycle Light◈Side/Cab Marker Lights◈Special Model Lights◈Third Brake Lights Lubrication System◈Dipstick◈Engine Oil Cooler◈Oil Pan◈Oil Pump Other Parts◈Shackle Kit◈Wheel Lug NutsNew List Item For Nissan Altima Maxima 2013 2014 2015 Remote Keyless Entry System 5 Buttons USD 27.78 For 1999-2008 Honda Sportrax 400 2012-2014 TRX400X Rear Axle Carrier Bearing Hub USD 58.85 For 07-13 GMC Sierra 1500 Truck Hood Molding Trim Chrome GM1235109 10385156 USD 42.95 For 07-13 Benz W221 S550 S600 S65 S63 Trunk Spoiler Wing Matt Black USD 53.85 Fits 2006-2008 Dodge Ram 1500 Front Headlights Assembly Left + Right Sides Set USD 83.89 Pair Headlights Assembly For 2006-2011 Honda Civic 2Dr Black Kit Headlamps Set ECCPP- Headlights Assembly
Fit For:
2006-2011 Honda Civic 2 Door Coupe
Package Includes:
Pair Headlight Assembly Left + Right
Features:
Plug and Play Operation, Direct Bolt-On OE Fitment or Replacement for the Stock Unit
Comes with a Complete Set of Headlights (Driver and Passenger Side)
Brings a Different Appearance to Vehicle thats Great for Show Use or to Replace Old and Worn Headlights
Requires no Modification or Drilling
Brand New and High-quality
Waterproof:The whole sealing construction can prevent moisture from entering the inside of housing.
Dust proof:The full sealed design will prevent the ingress of rain, dust and other foreign matter.
Heat Dissipation:With efficient heat dissipation, the construction of headlight will be protected and its useful life will be extended.
Note:
1.High quality lights.Safety and Durable.
2.DOT/SAT approved for street legal. Safety & Fashion.
3.High grade ABS plastic. For toughness, impact resistance, and heat resistance.
4.Condition: 100% Brand New and High Quality
5.Material: ABS Plastic Housing / Polycarbonate Lens
6.100% Brand New!
7.Professional Installation is Highly Recommended.
8.Installation Instruction is NOT Included.
Installation:
Install:
1.Undo the screws, clips, or retainer springs that hold the headlight in place.
2.Disconnect the wiring from the assembly.
3.Detach the headlight from the vehicle to replace it with a new one.
4.Fit in the new headlight assembly.
5.Fix the new headlight into place and make sure that the screws, clips, or retainer springs used are sealed.
6.Reconnect the wiring that was unplugged from the assembly.
7.Put back the grille and other components that you removed. Seal them back into place.
8.Test the new assembly.
Adjust：
Before you begin to adjust the light, make sure check the alignment of your lights first. Park the vehicle about 10 to 25 feet from the wall with the lights aimed at the wall. The centerlines of the headlights should not be any higher than 3.5 feet above the ground.
1. 【Find the adjustment screws】Firstly, locate the adjustment screws on your vehicle.
2. 【Adjust the headlights individually】The headlights should be adjusted one at a time. Put a rag or towel over a chair in front of the light you want to block. Covering the light assembly directly can damage the plastic lens.
3. 【Adjust the vertical field】The screw on the top of the light housing should be turned clockwise to raise the lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light beam shines directly on or just below the center of the tape line on the wall.
4. 【Adjust the horizontal field】The screw on the side of the light housing should be turned to get the right/left adjustment correct. Adjust the lens so that the most intense part of the beam is to the right of the vertical line.
5. 【Test your results】
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
