Custom LED Stage II Load Equalizer (Pair)
MANUFACTURER DIRECT PURCHASE with WARRANTY!
- Provides approximately the same load as a 25 Watt incandescent bulb.
- Fixes the fast-blink, no-blink and 4-way blink problems.
- Comes with non destructive quick-tap connectors.
- Comes with detailed installation instructions.
- Superior \"Oversized\" design prevents excessive heat buildup.
- 2 Load Equalizers per order - one for left blinker, one for right blinker.
- 1-year Warranty & Satisfaction Guarantee!
- In stock!
OVERVIEW
The Custom LED 25-Watt Load Equalizer (formerly known as our Stage II Load Equalizer) may be for you if your OEM turn signal lamps are 20 to 30 Watts each, and the following matches your situation after changingthem:
- the blinkers work but blink faster than stock
- the blinkers do not blink at all - either they turn on and stay on solid or they don\'t even come on at all
- the left and right directional signals illuminate at the same time when activated (4-way blink problem)
Our 25-Watt Load Equalizer is basically a 25 Watt power sink that will make the OEM flasher relay think your stock turn signal bulbs are still there! This means, if you install our 25-Watt Load Equalizer in each blinker location that there was a 20 to 30 Watt OEM incandescent turn signal lamp - that has been replaced by an LED lamp - your blinkers will blink normally.
Our 25-WattLoad Equalizer is enclosed in a water tight housing that can be mounted anywhere on the bike. Our Load Equalizer is also perfect for automobile applications that have a dedicated turn signal circuit (not shared with the brake light for example. If shared, you will need ourHeavy Duty 25-Watt Load Equalizersinstead).
Our Load Equalizer couldn\'t be easier to install! The device is small and connects to the turn signal wires only. Your order will come with detailed instructions and simple tap connectors that do not require any cutting of the factory wiring!
Our Load Equalizers are over-designed and over-sized for excellent heat capacity. They will not get too hot under normal operation. You wont have any overheating problems with our products!
In general, you will need one Load Equalizer for each stock blinker bulb you removed or replaced with LEDs or smaller incandescent bulbs.You will need one Load Equalizer for each side, therefore orders are automatically placed in pairs.
BEFORE CHOOSING A LOAD EQUALIZER TO CORRECT YOUR BLINKER FLASH RATE, BE SURE TO SEE OURELECTRONIC LED FLASHER RELAYWITH PLUG AND PLAY CONVENIENCE! IT\'S THE BETTER AND CHEAPER SOLUTION TO THE PROBLEM!
NOTE: The Stage II Load Equalizer can NOT be used on vehicles where the brake light and turn signal are the same circuit. Some automobiles have a shared bulb for turn signals and brake lights. If the \"brake light\" blinks on your car when the blinkers are on, then you have a shared circuit and can not use this product. The Stage II Load Equalizer is not recommended for applications where the power will be applied constantly as in a brake light situation (foot on brake in traffic or at a traffic light).
INSTALLATION
The Custom LED Stage II Load Equalizers come with detailed installation instructions.
Installation of the Stage II Load Equalizers is as follows:
click icon to download
Adobe Acrobat Reader is required to view this file.
If you are having problems viewing the file, please download the free software here.