OPT7 Aura LED Light Kit
Full Color Spectrum with SmartColorTM 5050 RGB LEDs
With a combination of LED strips and smart color technology, the Aura Interior Kit will give your vehicle's interior the attention it deserves.
With endless customizable combinations, you can match your décor or match your mood without having to worry about taking apart your dash board to change colors.
With advanced bass activated technology and a wireless remote, you'll be on the cutting edge of interior lighting.
Hear It, See It, Feel the Vibe w/ SoundSync Exclusive Technology SoundSyncTM
It comes with a variety of patterns and modes so you can have fun and create your own custom lighting experience.
True Plug Play Installation - 5 Minute Setup
With you in mind, we've simplified the installation process to a simple Car 12V Charger Adapter. Just plug it in and hit ON.
E-Z Programming
Once installed, easily select the color and pattern you want with our one feature-rich E-Z Remote.
- Multi-color selections
- Brightness dimming selections
- On the E-Z Remote, our modes are: Solid, Single Color Strobes, Multi-Color Fade, Multi-Color Cycle, and SoundSync.
AURA Original Kit Included:
- 1 x 21-Key Handheld Remote
- 1 x Cigarette Power Adapter
- 1 x AURA V2 Control Box (O) + 4-Pin Round RGB Pre-Attached Connectors
- 4 x 12" Single Row LED Strips with Adhesive Back
- 2 x 5ft + 2 x 10ft Light Strip Extension Wire (4PC)
- 1 x Pack of Mounting Kit and Zip Ties
NOTE: The LED connectors have been updated to round cap. If you would like to upgrade to AURA PRO Control Box, please reach out to our Customer Support Team.
Automotive Adhesive Tape
Our premium strip kits use strong binding tape for a lasting hold you can trust.
Tip on applying adhesive LED strips securely:
1. To prep the area you wish to mount the LED Strip. Wash the installation point with warm water, then wipe it dry.
2. Dampen a clean cloth in warm water, then scrub the surface to remove debris. Any grime left behind could prevent the LEDs from sticking, so thoroughly clean the surface until it’s free of dirt and scuff marks.
3. Remove any moisture left over with a clean, dry cloth or give the surface 30 minutes to air dry. Next, use the adhesive booster that we provide to wipe the area for a ready to stick surface.
4. Peel the adhesive backing off and press the LEDs in place. LED lights are like stickers, so wait until you’re ready to put them on the wall before pulling the backing off. It’s best to do this a little at a time. Start at one end of the surface, peeling the backing off of the initial LED light. Position it, press it flat by hand, then continue placing the rest of the strip. Take your time. Make sure the LEDs are in the right place so you don’t have to move them later.
Unfortunately, your browser does not support videos.