ATTENTION: INTERNATIONAL AND DOMESTIC E31 E32 V12 OWNERS, I CAN REFURBISH YOUR EXISTING THROTTLES DK MOTORS AT A DISCOUNT IF YOU SEND THEM TO ME. CONTACT ME FOR MORE INFORMATION
Refurbished throttle bodies (DK motors), they work like new -silky smooth! This will improve throttle response and fuel consumption, smooth out the idle and eliminate EML light. Will fit 850i 750i 850Ci 850CSI 750iL1988-1994. Over time the DK motors tend to get worn outand stuck, encoder face gets worn in tracks, this causes bad throttle response, ruff idle and EML light comes on sending the engine into limp home mode. New throttle bodies from the dealer are very expensive, upwards of $2000 ea. If you buy used they probably have already failed or will fail soon. These refurbished throttle bodies will last you just as long as the new ones would.All M70 S70throttle bodies with over 70k miles on them start under performing delaying throttle response and eventually fail all together.
There is a specific throttle synchronization procedure that you need to follow once the new units are installed. Here it is:
1. Run engine to operating temperature
2. In 1st gear run the engine up to 5000 rpm and then let it coast down (still in 1st) down to idle and let it idle for 10 seconds
3. Do step 2 two more times for a total of three times.
4.Place the car in neutral or park
5. Idle for at least 5 minutes.
6. Shut the engine off for 10 seconds
7. Restart the engine
SHIPPING OUTSIDE THE USA IS $80
I WILL REFUND $80 PER PAIR IF THE OLD CORES ARE SEND BACK TO ME.
ALL PARTS HAVE 6 MONTHS WARRANTY .
LOCAL PICK UP IN BAY AREA, CA CAN BEARRANGED.
Some people claim to refurbish throttle bodiesbut instead only clean them up. I have a different approach returning them to original Bosh factory spec. With time the encoder face gets \"worn in\" from encoderwhiskers traveling on it\'s surface, because of this condition no matter how much you clean the throttle it will stillunder performand throttleresponsewill be delayed/sluggish. Over the years I have developed a procedure where Ire positioneach encoder whisker a fraction of a mm at a time onto unused encoder face surface, then re test the throttle electricallyuntilit is back to factory new specification. This is very time consuming procedure requiring skill but this is the only way to truly refurbish these throttles.Besides this eachthrottle body gets disassembled to the lower gears, every part is inspected and replaced as needed, rust in the gears is eliminated, commutatorbrushes are replaced if worn beyond 40%, electricallybench tested for proper operation after the refurbishment.In the end the throttle body is brought back to like new working condition. I have lowmileageE38Siemens throttles for M73 V12 engines and can refurbish electronic EML throttles or DK motors for E32 735i / E34 535i M30 V6 BMW. Also available upgrade 210mm differentials, 3.45LSD and 3.15LSD.
Some video of refurbishment process:[link removed by ]
