QuattroBrake Caliper High Temp. Vinyl Decal Stickers Set Of 4
Quantity: 4 Decals
2 Large Front/2 Small Rear
Default Size: Large 4\" Wide; Small 3\" Wide
Default Color: White
Please specify color of choice in notes to seller or send a message immediately after purchase, otherwise Default decals will be sent.
Returns:
• Return unused, undamaged product within 14 days and receive a full refund
• Buyer is responsible for shipping return
We are not responsible for non proper installation!
About Vinyl Decals:
These are DIE-CUT decals meaning there is no background. If there is a background color in the picture, it is used only as a example.
The background color will be the color of thesurfaceyou place the stickeron, or clear if you put it on a window.
Vinyl Decals come in 3 pieces:
1.Top layer is a transparent transfer tape.
(Holds your decal or sticker together until it is applied)
2.Middle layer is your actual decal or sticker
(It is sandwiched between the Application Tape and the Wax Backing)
3.Bottom layer is the wax backing.
(protectstheadhesiveuntil thedecalis ready to be applied)
Application Tips:
1.Do not apply on extremecold or hot Surfaces. Ideal temperature must be between 60°F & 90°F.
2.Do not touch the adhesive backing, oils from your skin will prevent sticking.
3.Before applying decal make sure there is no wax or oily products on the surface
Application Instructions:
1.Rub the sticker to be sure the transfer tape is properly adhered to the sticker.
2.Clean and dry the desired area. Stickers will stick best to clean smooth surfaces.
3.Remove the wax backing slowly making sure the sticker stays adhered to the transparent transfer tape
4.Carefully position the sticker to the desired area.
5.Rub the sticker from one side to the other, eliminating any air bubbles.
5.Use a object like a credit card to make sure the entire sticker is fully adhered to the surface.
6.Slowly remove the transfer tape, making sure no part of the sticker remains on the transfer tape.
7.Check for air bubbles. In most cases air bubbles can be worked to the edge of the sticker,
but if not, a pin hole will allow the air out and become virtually invisible.
Your sticker is now worry free!
