Description:
● A/C compressor is to meet or exceed specifications.
● All compressors are built using the latest compressor technology available today and using strict processes.
● New bearing, new seals and gaskets, new coil, lathed clutch assembly.
● Tested for noise, vibration, durability, vacuum decay, and pressure decay to ensure no leaks.
● The function of air compressor is to compress air, not to cool air. A product that has no signs of leakage, abnormal sound and has sufficient pressure can be certificated as a qualified product.
Will fit Following Models：
Chevrolet Cruze Eco Sedan 4-Door 1.4L 1364CC 83Cu. In. l4 GAS DOHC Turbocharged 2012-2015
Chevrolet Cruze LT Sedan 4-Door 1.4L 1364CC 83Cu. In. l4 GAS DOHC Turbocharged 2012-2015
Chevrolet Cruze LTZ Sedan 4-Door 1.4L 1364CC 83Cu. In. l4 GAS DOHC Turbocharged 2012-2015
Chevrolet Cruze Limited Eco Sedan 4-Door 1.4L 1364CC 83Cu. In. l4 GAS DOHC Turbocharged 2016
Chevrolet Cruze Limited LT Sedan 4-Door 1.4L 1364CC 83Cu. In. l4 GAS DOHC Turbocharged 2016
Chevrolet Cruze Limited LTZ Sedan 4-Door 1.4L 1364CC 83Cu. In. l4 GAS DOHC Turbocharged 2016
Installation instructions：
1.Remove compressor, receiver drier or accumulator, orifice tube or expansion valve.
2.Flush the condenser and evaporator using NON-OIL BASED A/C flush. On expansion valve systems. The valve must be removed before the evaporator can be flushed. Flushed condensers from outlet to inlet and evaporators from inlet to outlet.
3.Drain all the oil from the new compressor and dispose of according to local, state and federal laws.NOTE:if you compressor has a drain plug you will need to open it up and drain what oil is in there too.
4.Install half oil charge into the compressor and the remainder throughout the system. Turn compressor shaft 8-10 full revolutions to insure front seal and other internal parts are lubricated.
5.Install new receiver drier or accumulator and new orifice tube or expansion valve.
6.Evacuate the A/C system for a minimum of one hour.
7.After evacuation install half the refrigerant charge and let the system set for 1 minute. This will allow the refrigerant to pick up oil and spread more evenly throughout the system.
8.Add the remaining charge of refrigerant as called for by the manufacture.
Note:
*Please make sure the installation site is clean. Or, it will cause operating obstruction, even make the temperature of the compressor very high, and the belt on the clutch may melt.
*Because the item is with oil when sent to you, so there is no need to add oil when you use it the first time. But you need to add the refrigerant , please add about 500g, don\'t need to fill up. There may be noise if the refrigerant is added too much.
