4Pcs 02 Oxygen O2 Sensor For Nissan Frontier Pathfinder Xterra 4.0L Up + Down
Please check fitment notes & description for accurate information.
*Warranty: 1 Year
Specification:
*Brand New
*Direct Plug-In Replacement.
*4 & 5wire configuration
*Built and tested to strict quality control standards
Note:For clarification purposes:
- Upstreamlocation is between the catalytic converter and the engine
- Downstreamlocation is between the catalytic converter and the tailpipe
If you have a bad O2 sensor causing your vehicle to run poorly or fail an emission test then this is the part for you.
Install Note:
You may be required to reset the vehicle computer after installation of this part.
Fit Vehicles:
for Nissan Pathfinder 2005-2006 4.0L V6
for Nissan Frontier 2005-2006 4.0L V6
for Nissan Xterra 2005-2006 4.0L V6
Position:Upstream & Downstream
Reference OEM #:234-5060, 234-4297, 234-4313，226936M400, 226937Y000, 226937Y020, 226937S000
Package Includes:
4 x Oxygen Sensor(2x Upstream+2x Downstream)
Oxygen Sensor\'s Location:
Must Know Before Buying:
The following information is for instructional and guidance reference only. We try and make them as accurate as we can.
If Check Engine Light is on or an OBDII Trouble/Fault code occurs after installation, check the sensor with a voltmeter as below.
If the sensor is good, further diagnosis is required. There\'re many different codes for specific functional failures, which are NOT necessarily relevant to the sensor. Find out what the Code means before leaving any responses.
Items that have been installed, altered or contaminated arenon-returnable.
1. ONLY a defective sensor after tested by a voltmeter is applied to manufacturer warranty.
2. 20% restocking fee is required if buyer bought wrong items due to not paying attention to fitment information and ask for return.
The Price, Quality & Functionality of the O2 Sensor is fully covered under our warranty & return policy. However, refund for any labor cost, expense in a dealer shop or damage due to wrong installation is NOT covered.
Q: How do I know the O2 sensor is good or not?
A: The only way to know if the O2 sensor is functioning normally is to check its responsiveness to changes in the air/fuel mixture, by Voltage Measurement or Waveform Simulation.
Use a 10-megaohm digital voltmeter. Hook up the voltmeter\'s red probe to the sensor\'s signal wire and the black probe to engine ground. (Use back probe method, DO NOT pierce the wire.) For a good sensor, voltage should fluctuate constantly between 0.1 and 0.9 volts after starting the engine for 2 or 3 minutes.
