350Z 03-05 Dashboard Cubby Triple Gauge Pod Angled
This 3D printed gauge part replaces the storage area of the cubby in the dash. Designed to fit three 52mm or 2 1/16 aftermarket gauges. No cutting or modification is required and reuses the stock cubby hardware. It will work on any 350Z 03-05. Be sure to check your cubby design before purchasing. Swapping to a newer cubby is a popular mod.This design will not work on any other year 350Z. I also make a straight version of this design of the 03-05 350Z.
This does not come with gauges, interior trim or hardware. This listing is only for the 3D printed part.
Installation is simple and requires basic hand tools. You remove the center dash trim, remove the back of the cubby and replace them with the 3D printed gauge pods. This print has mounts for screws built in so it fits in the OEM spot without any modification.
I designed this with a 52.5mm hole for the gauge. Not all gauges are 52mm be sure to test fit your gauge DO NOT JUST PRESS IT IN. If you feel heavy resistance inserting the gauge the design will need sanding or you have a gauge larger than 52mm. Gauges are designed to fit snug so you don't have any rattles or noises. I've found that the lower end gauges are either larger or smaller than 52mm. If your gauge is loose add a layer of tape until it fits.
Made out of ABS plastic the same material most automotive interior plastic is made of. This is a raw 3D printed part you will see small lines from being made. The part can be sanded and painted and you won't see any lines.
I have many 3D printed gauge pod designs for the 350Z and G35. If your looking for something else check out the rest of my designs.
If you have any questions just ask!
350Z 06-08 Gauge Pod Angled Dashboard Cubby
350Z 03-08 Center Dash Gauge Pods
350Z 03-05 Gauge Pod Dashboard Cubby Angled
350Z 03-05 Gauge Pod Dashboard Cubby Straight
G35 03-04 Manual Ash Tray Double Gauge Pod Angled
G35 05-07 Manual Ash Tray Double Gauge Pod Angled
