Product Specifications:Colors available: Red Light, Blue Chrome Housing. (We also have Blue/White Light,Just leave a message when you can pay.）The power: DC12V +/-10Wiring length: 0.6meterMaterial : LED+PVC+ABSVoltage: 12Vlife span: more than 100000 hoursSize: 17.6*6.9cm/7 inches
Fit:Fits for Ford Escape 2003-2007Ford Excursion 2000-2004Ford Expedition 1999-2006Ford F-150 2006-2008Ford F-150 2004-2012 (Tailgate without backup camera)Ford F-250 Super Duty 2011-2016Ford F-350 Super Duty 2011-2016Ford F-450 Super Duty 2011-2016Ford F-550 Super Duty 2011-2016Ford Five Hundred 2005Ford Freestar 2004-2007Ford Freestyle 2005Ford Ranger 2003-2011
Note:
this car logo light maybe can not both fit your
Rear and Front logo.because your car Rear and Front logo
maybe different size.
Please measure your original Rear and Front logo
before you place an order!
Product Features:
1:It is easy to install,can be used more than 10000 hours
2:This product should be installed in the original position
to replace the original logo(at the back of the car)
3:Using high-quality automotive-specific double-sided adhesive,
sticky special strong special lasting!
The use of special vacuum plating technology,
both to ensure the original car with the standard gloss,
but also to ensure high transmittance and brightness uniformity
4:High quality water plating car badge, Laser and Reflective mirror
5:When the license plate lamp is turned on,
the car logo light will be turn on too, which shines the logo in the night .
6:Special waterproof and dustproof design!
This product is designed for car modification enthusiasts,
specially designed during the day and logo does not light,
there is no difference with the original logo,
LED logo lights will be lit when the vehicle license
plate at night light to open the car standard night becomes a dazzling,
full of a sense of future technology,
high light the distinguished lineage of your car.
Installation Notes:Before you begin,prepare the following tools:1. Flat head screwdriver
2. Phillips screwdriver
3. Insulating tape 4. Towel 5. Pliers1. First in the box marked with a towel next to the car,
with a flat screwdriver pry the car standard,
shop towel is to prevent scratches the body
2. Note first double-sided tape stripping the body,
when prying force moderate, do not be too fierce, little by little,
slowly pry down,
clean up the car body and the standard double-sided adhesive
3. Using a Phillips screwdriver to remove the inner compartment
of the rear compartment, pay attention to some parts of the clamp,
be careful to remove the noise board can see a variety of lines.
4. Now again to install the car standard lights,
the car lights to mark the power cord through one of the car
standard positioning holes, wear inside the car
Tear off the car on the back of the single-sided plastic lights,
while pulling the side of the car lights to stick to the car body,
pressed.
5. Mark lights installed, and now the power supply.
The car to be connected to the license plate lights after the
license light power,
so when you turn on the night light when the lights will be marked
at the same time to find the license plateafter the power connector
6. First unplug the plug, positive and negative stripping a hole,
revealing wire core, according to the red on the red,
black and black good line,
do not forget to use insulating tape wrapped,
and finally plug the plug back again!
Replace the rear cover noise board!
